Refer to Diagnostic class (standard): 3
The device that was expected at the position (x), was not found.
|
Cause |
Solution |
|---|---|
|
Detected error when assigning the identification features. |
Verify and correct if necessary the settings of the identification features (for example: ConfiguredTopologyAddress) |
A Sercos slave listed in the PLC configuration cannot be found in the Sercos bus.
|
Cause |
Solution |
|---|---|
|
Sercos slave not present in the Sercos bus. |
Connect the Sercos slave to the Sercos bus or remove the Sercos slave from the PLC configuration or parameterize it as a virtual device |