|
Type |
AD |
|
Devices supporting the parameter |
Lexium LXM52 Drive, Lexium LXM52 Linear Drive, Lexium LXM62 Drive, Lexium LXM62 Linear Drive, Lexium ILM62 Drive Module, Lexium LXM62 Power Supply |
|
Traceable |
No |
Displays the DC bus voltage of the device in Volt.
NOTE: For further details, see the technical data in the operating instructions of the device.
NOTE: The parameter value is transferred from the slave to the master via the parameter channel of the Sercos by every access. Typically, this takes about 10 ms. By a high capacity of the parameter channel, times up to 1 s can occur. If the Sercos bus is in phase 0 or 1, then a standard value is indicated here. If the Sercos bus is in phase 3 or 4, then the parameter value is transferred and indicated. In the Sercos phase 2, the parameter can be read through the application.
NOTE: The parameter value is transferred from the slave to the master via the real-time channel of the Sercos. If the Sercos bus is not in phase 4, then a standard value is indicated here. If the Sercos bus is in phase 4 (operating phase), then the parameter value is transferred and indicated via the Sercos bus.
