Type:

Enumeration type

Available as of:

V1.1.4.0

Versions:

Current version

StartOnSignal

1

Start signals are either generated by the connected Touchprobe sensor or via the Bit xStart. With this type of start signals, the products must not have any phase position, only the distance of the Touchprobe sensor to the transfer point is of relevance. If the products do not have any phase position or different distances, a compensation motion is carried out.

SyncOnPhase

2

Start signals are automatically generated. During each master period, a start signal is generated exactly at lrPhase. External inputs are irrelevant. This setting is particularly suitable in order for unloading products from the trains in-phase.

MasterSelectPos

3

The start signals are generated via a Touchprobe input. The Touchprobe input is queried exactly once during a master period, at the position lrMasterSelectPos. If the Touchprobe is occupied at this time, a step is executed. If the Touchprobe is not occupied, no step is executed and the trains stop. The products are stored directly at lrPhase, and no correction is carried out. If MasterSelectPos is selected, then the products must have the correct phase position before inserting them into the MultiBelt. The motion equates approximately to the DualBelt one.